Factory Reset

warning

If you reset the MidTeq EMS, the network configuration will be reset to DHCP. Take care if you perform a factory reset remotely, because the MidTeq EMS might lose network access if it needs a specific network configuration!

warning

Before you perform a factory reset, it is recommended that you make a backup of the settings.

Through the commissioning interface

Lost access to commissioning interface

You can retrieve the IP address through mDNS. See also Option 3.2 of Accessing the commissioning interface.

You can reset the MidTeq EMS through the commissioning interface, from the settings tab. Scroll down to "Factory reset", and click "Factory reset".

Without the commissioning interface

Model OM1

MidTeq (Model OM1)

Switch the MidTeq EMS and wait until it has booted (LED is cyan or blue during startup). This can take several minutes without internet. When the MidTeq EMS is on, you can reset the MidTeq EMS by pressing the physical reset button in the pin hole next to the RS485 interface for 10 seconds. The status LED will flash red-green. Release the reset button when the status LED becomes blue. The MidTeq EMS is now rebooting.

tip

Make sure you feel the reset button clicking when pressing it.

Model EDS

MidTeq (Model EDS)

This model does not have physical reset button. You must reset the MidTeq through the commissioning interface.

Model M1S

MidTeq (Model M1S)

This model does not have physical reset button. You must reset the MidTeq through the commissioning interface.